Разработка и печать кейса для DC-DC преобразователя.
Case for adjustable DC-DC stepdown converter with display (like this). PCB dementions 60mm * 37mm.
I’m soldered a new 17mm-height buttons instead defaults.
The board is held by the screws housing. Using 3,0mm*20mm screws.
Holes for 2mm diameter wires, but you can use more thicker, just break a «wire separator» in bottom part.
If you do not need any symbols on top cover — use «top_clean.stl». (rotate top cover to 180 degrees)
Thingiverse: https://www.thingiverse.com/thing:2808246